When a component or PCB gets too hot, it can cause problems with operation. Generally, the best way to prevent this from happening is to use a thermal pad.
These heat-dissipating pads are a type of thermal interface material and are typically placed between the hot component and the heat sink to conduct the heat away from the components and into the heat sink. They are available in a variety of materials that can be custom-cut and fabricated to fit any application and provide effective heat transfer.
If you are looking for a high-performance thermal pad to use with your heat sink, try an elastomeric type of pad. These types of pads come pre-cured and do not contaminate electronic components as thermal paste does.
They are also much easier to apply than thermal paste because they do not need to be cut to a precise size and can be applied directly onto the heat sink. The material they are made from is also not susceptible to the same degradation that thermal greases can be subjected to, allowing them to perform their job for a longer period of time without issues.
A good rule of thumb is to use the thickest thermal pad that will fill the gap between the heat sink and the component perfectly and will not leave an indentation in the heat sink. Using a thermal pad that is too thick can make the heat sink contact less effective, which may cause heat to build up in the component or even damage it.
Yes, you can put a thermal pad on top of the thermal paste, but this is not recommended and will reduce the performance of both. Thermal paste will fill in the pores of the thermal pad and reduce its ability to dissipate heat. It is also not recommended to use them together because thermal pads can be a good solution for many applications, while thermal paste will only serve one purpose.
Thermal pads are available in a wide variety of thicknesses, from 0.010 inches to 0.250 inches. They are die-cut into a variety of shapes, including squares, stars, and rectangles. They can be applied by hand or with a thermal adhesive to the underside of heat sinks. They can also be cured with an oven or a heated spray gun to ensure they are completely dry.





